On Sun, 2010-03-28 at 15:16 -0700, Darlene Wallach wrote: > After I partition, format and label the Seagate FreeAgent Go 1T drive > and I'm ready to mount it is this what I should use: > > mount -t fuseblk -o rw,nosuid, nodev,allow_other,blocksize=4096 > /dev/sdb1 /media/<myLabel> > > Should I add - uhelper=hal to the mount? > > mount -t fuseblk -o rw,nosuid, > nodev,uhelper=hal,allow_other,blocksize=4096 /dev/sdb1 > /media/<myLabel> > > what about adding shortname=lower to the mount? > > mount -t fuseblk -o rw,nosuid, > nodev,uhelper=hal,shortname=lower,allow_other,blocksize=4096 /dev/sdb1 > /media/<myLabel> > > Thank you for your attention, consideration, and feedback. ---- What is it that you hope to accomplish by forcibly mounting this rather than just allowing the natural mount occur when you plug it in? Craig -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
