On Tue, Feb 09, 2010 at 13:16:20 -0700, reg@xxxxxxx wrote: > > Screen 0: minimum 320 x 200, current 800 x 600, maximum 4096 x 4096 > VGA-0 connected 800x600+0+0 (normal left inverted right x axis y axis) 0mm x > 0mm > 800x600 60.3* 56.2 > 640x480 59.9 > DVI-I-0 disconnected (normal left inverted right x axis y axis) The video driver did not think the other modes dectected in X11 were usable. This might because of lack of proper EDID or some other reason. > Modes "1280x1024" "1024x768" "800x600" "640x480" This only says which modes you want to try and use. A combination of this list and the detected modes is used to get the mode used by default. If you know that other modes are valid and want to allow them to be used, you need to add something like this (appropriate for both your video card and your monitor or you might toast them): Section "Monitor" Identifier "Monitor0" ModelName "NEC MultiSync LCD2010X" HorizSync 31.0 - 80.0 VertRefresh 56.0 - 85.0 Modeline "1280x1024_70.00" 129.00 1280 1368 1504 1728 1024 1027 1034 1069 -hsync +vsync Option "dpms" EndSection You can use cvt or other programs to generate modelines for particular resolutions and refresh rates. (Also you can generate different ones for LCD and CRT displays. I don't understand all about that, just that there are differences.) You want to make sure the sync and refresh rates aren't out of spec for your hardware. -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
