gordon@xxxxxxxxxxxxxxx wrote:
Dear List
Thank you for you help I have installed the ipw2200 drivers. When I
issue the command iwconfig I get :
sit0 no wireless extensions.
eth1 unassociated ESSID:off/any
Mode:Managed Channel=0 Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=20 dBm Sensitivity=8/0
Retry limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
I still can not connect to my wireless network, Where do i configure my
wireless key and ESSID ?
man iwconfig. You should start with "iwlist scan" to be sure your ap is
seem, then iwconfig after that.
I was looking at this the other day, wondering if it was worth adding
wpa software to my older installation, given that I use the wireless
only as an untrusted connection and then set up a vpn to my firewall
before any real data goes over the connection.
--
Bill Davidsen <davidsen@xxxxxxx>
"We have more to fear from the bungling of the incompetent than from
the machinations of the wicked." - from Slashdot
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
