David Krings wrote:
Mikkel L. Ellertson wrote:
David Krings wrote:
If bios sees the drives as separate things, then that's how you have
to install grub, since it has to call bios to load the kernel. On a
real hardware raid, bios will only see the array.
BIOS sees them as one drive. A working F7 sees them as two drives
and as
one under the /mapper dir.
I could see this to be a BIOS problem if nothing loads, but GRUB does
load at least so far as that it gets to the grub> prompt. So it is not
that BIOS is confused. It is purely a GRUB issue.
It could be a grub configuration issue. It could be that it is using
the wrong BIOS device number when it tries to load the files from
the grub directory. It would be interesting to see the contents of
/boot/grub/device.map and /boot/grub/grub.conf. It would be
interesting if the BIOS mapped the PATA devices 80 through 83, and
the SATA drives as 84 and 85. (I seam to remember some BIOS's that
did something like that is the past.) I would think that would make
the drive hd4 instead of hd0.
Mikkel
Well possible, but for now I dumped the broken GRUB and made this box
to boot into XP only. I did not kill the F7 partition and may get
back to it later. I just want to finally use my new system.
I leave it at that as there seems to be no way to get an answer to my
original question. :(
David
Hi David. It might be that the reason your grub stopped is because
of that new kernel you were yum update getting. That kernel might have
stopped Grub from working. I suggest you load F7 again in a simple one
hard drive system. Then check out grub which the loader should have
installed right. Then you have both for at least a while.
--
Karl F. Larsen, AKA K5DI
Linux User
#450462 http://counter.li.org.
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list