> Hi all, > > I'm in the process of reconfiguring a FC5 Proliant servers dual nic > > But before I actually change anything ( server is in production ) I > need some help with my setup as this is the first time I've ventured > into this :-) > > I hope some of you gurus can help me with this and point out if this > is the correct way, or if there's an easier/better way to do it, and > if I'm missing anything in the setup. > > Any input/help would be greatly appreciated > > All the best > > Lars Sorensen > > Below is the setup I've seen on another running server: > > > > cat /etc/modprobe.conf > alias bond0 bonding > options bond0 mode=1 miimon=100 > alias eth0 tg3 > alias eth1 tg3 > alias scsi_hostadapter cciss > > > [root@localhost ~]# cat /root/ifcfg-eth0 > # Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet > DEVICE=eth0 > BOOTPROTO=none > ONBOOT=yes > MASTER=bond0 > SLAVE=yes > USERCTL=no > TYPE=Ethernet > > [root@localhost ~]# cat /root/ifcfg-eth1 > # Broadcom Corporation NetXtreme BCM5704 Gigabit Ethernet > DEVICE=eth1 > BOOTPROTO=none > ONBOOT=yes > MASTER=bond0 > SLAVE=yes > USERCTL=no > TYPE=Ethernet > > [root@localhost ~]# cat /root/ifcfg-bond0 > DEVICE=bond0 > BOOTPROTO=none > ONBOOT=yes > USERCTL=no > IPADDR=0.0.0.0 > > [root@localhost ~]# cat /root/ifcfg-bond0.10 > DEVICE=bond0.10 > BOOTPROTO=none > ONBOOT=yes > USERCTL=no > REORDER_HDR=no > IPADDR=212.xx.xx.248 > NETMASK=255.255.255.224 > GATEWAY=212.xx.xx.225 bond0.10 means you are using VLANs (802.1q). You need to add VLAN=yes in /etc/sysconfig/network. And in the switch you need to configure support for 802.1q. Regards, Fernando. -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
