-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
This has me completely flummoxed.
I have a Sun Fire x4200 with four drives internal drives on an (LSI)
SAS1064 RAID controller. Drives 0&1 have been mirrored, as have 2&3.
The installation of FC5 (and FC6 tests) goes without a problem.
HOWEVER, after the reboot the system stop booting at the point where
grub should start displaying.
I've tried a number of variations, eg. grub on boot volume rather
than MBR, etc.
Interestingly enough, if I don't mirror the drives, FC boots without
a problem after the installation. If I then use the RAID controller
to mirror the boot drive, I'm back to the "bad" behavior where grub
never appears.
I hope someone out there may have run into this and solved it.
- -David
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.5 (Darwin)
iD8DBQFFOh81F5XSfHP90EcRAhjcAJ0alGjAzJWBD81RW0k3Jc/K9wrOpACcDDdO
+Jenz8qjHyWIQqfwRi8FcwQ=
=8ph8
-----END PGP SIGNATURE-----
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
