I just installed the latest kernel (2.6.18-1.2200.fc5smp) and now see a 40 second time out on amy disk controller at boot time. This didn't occur before the update (2.6.17-1.2187_FC5smp). Once the time out is over, the boot proceeds normally. Everything else seems fine. Should I report a bug? Can I suppress the time out (whatever it is)? dmesg: Freeing unused kernel memory: 244k freed Write protecting the kernel read-only data: 383k Time: tsc clocksource has been installed. SCSI subsystem initialized libata version 2.00 loaded. ata_piix 0000:00:1f.2: version 2.00 ata_piix 0000:00:1f.2: MAP [ P0 P2 P1 P3 ] ACPI: PCI Interrupt 0000:00:1f.2[C] -> GSI 20 (level, low) -> IRQ 217 PCI: Setting latency timer of device 0000:00:1f.2 to 64 ata1: SATA max UDMA/133 cmd 0xFE00 ctl 0xFE12 bmdma 0xFEA0 irq 217 ata2: SATA max UDMA/133 cmd 0xFE20 ctl 0xFE32 bmdma 0xFEA8 irq 217 scsi0 : ata_piix ata1.00: ATA-7, max UDMA/133, 156250000 sectors: LBA48 NCQ (depth 0/32) ata1.00: ata1: dev 0 multi count 8 ata1.00: configured for UDMA/133 scsi1 : ata_piix ata2: port is slow to respond, please be patient ata2: port failed to respond (30 secs) ata2: SRST failed (status 0xFF) ata2: SRST failed (err_mask=0x100) ata2: softreset failed, retrying in 5 secs ata2: SRST failed (status 0xFF) ata2: SRST failed (err_mask=0x100) ata2: softreset failed, retrying in 5 secs ata2: SRST failed (status 0xFF) ata2: SRST failed (err_mask=0x100) ata2: reset failed, giving up Vendor: ATA Model: WDC WD800JD-75MS Rev: 10.0 Type: Direct-Access ANSI SCSI revision: 05 SCSI device sda: 156250000 512-byte hdwr sectors (80000 MB) sda: Write Protect is off sda: Mode Sense: 00 3a 00 00 SCSI device sda: drive cache: write back SCSI device sda: 156250000 512-byte hdwr sectors (80000 MB) sda: Write Protect is off sda: Mode Sense: 00 3a 00 00 SCSI device sda: drive cache: write back sda: sda1 sda2 sda3 < sda5 sda6 sda7 > sd 0:0:0:0: Attached scsi disk sda kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. $ lspci 00:00.0 Host bridge: Intel Corporation 945G/P Memory Controller Hub (rev 02) 00:01.0 PCI bridge: Intel Corporation 945G/P PCI Express Graphics Port (rev 02) 00:02.0 VGA compatible controller: Intel Corporation 945G Integrated Graphics Controller (rev 02) 00:02.1 Display controller: Intel Corporation 945G Integrated Graphics Controller (rev 02) 00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 01) 00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 2 (rev 01) 00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #1 (rev 01) 00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #2 (rev 01) 00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #3 (rev 01) 00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI #4 (rev 01) 00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 01) 00:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev e1) 00:1e.2 Multimedia audio controller: Intel Corporation 82801G (ICH7 Family) AC'97 Audio Controller (rev 01) 00:1f.0 ISA bridge: Intel Corporation 82801GB/GR (ICH7 Family) LPC Interface Bridge (rev 01) 00:1f.1 IDE interface: Intel Corporation 82801G (ICH7 Family) IDE Controller (rev 01) 00:1f.2 IDE interface: Intel Corporation 82801GB/GR/GH (ICH7 Family) Serial ATA Storage Controllers cc=IDE (rev 01) 00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller (rev 01) 02:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5751 Gigabit Ethernet PCI Express (rev 01) -- Garry Williams +1 678 656-4579 -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
