On Sat, Sep 23, 2017 at 1:12 AM, Davi Garcia <davivcgarcia@xxxxxxxxx> wrote: > Hi Peter, > > Thanks for your reply! > > I already tested with different 2A power sources, so I'm sure that this was > not the problem. But I just discovered the issue... I was using my old RPi > B+ and not my RPi2 (facepalm)! That was actually my first guess ;-) > Regards, > Davi Garcia > > On Fri, Sep 22, 2017 at 6:23 PM, Peter Robinson <pbrobinson@xxxxxxxxx> > wrote: >> >> On Fri, Sep 22, 2017 at 8:55 PM, Davi Garcia <davivcgarcia@xxxxxxxxx> >> wrote: >> > Hi all, >> > >> > I'm trying to use the latest Fedora ARM Minimal image (26-1.5) with my >> > RPi2 >> > but it gets stuck at rainbow screen. I tested the same device, with the >> > same >> > sdcard and power supply, but with Raspibian and the problem doesn't >> > happen. >> > >> > I'm using the following CLI to burn the image: >> > >> > # fedora-arm-image-installer --image=Fedora.xz --target=rpi2 >> > --media=/dev/mmcblk0 >> > >> > >> > Any advice? >> >> The rainbow screen indicates a couple of things, a non bootable image, >> a not powerful enough PSU (what amps is it?) or not a RPi 2/3 (what is >> the version number on the circuit board?). >> >> Peter > > _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx
