Hi Peter,
Thanks for your reply!
I already tested with different 2A power sources, so I'm sure that this was not the problem. But I just discovered the issue... I was using my old RPi B+ and not my RPi2 (facepalm)!
Regards,
Davi Garcia
On Fri, Sep 22, 2017 at 6:23 PM, Peter Robinson <pbrobinson@xxxxxxxxx> wrote:
On Fri, Sep 22, 2017 at 8:55 PM, Davi Garcia <davivcgarcia@xxxxxxxxx> wrote:
> Hi all,
>
> I'm trying to use the latest Fedora ARM Minimal image (26-1.5) with my RPi2
> but it gets stuck at rainbow screen. I tested the same device, with the same
> sdcard and power supply, but with Raspibian and the problem doesn't happen.
>
> I'm using the following CLI to burn the image:
>
> # fedora-arm-image-installer --image=Fedora.xz --target=rpi2
> --media=/dev/mmcblk0
>
>
> Any advice?
The rainbow screen indicates a couple of things, a non bootable image,
a not powerful enough PSU (what amps is it?) or not a RPi 2/3 (what is
the version number on the circuit board?).
Peter
_______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx
