On 09/16/2017 07:57 AM, Peter Robinson wrote:
On Fri, Sep 15, 2017 at 7:19 PM, Robert Moskowitz <rgm@xxxxxxxxxxxxxxx> wrote:
I think this one is even worst than 0913. At least with what little I
tested.
Still no ethernet, but the link is up. Further, I forgot to mention last
time, the config network option on the console is only offering the hostname
to change. No ethernet, not surprisingly. But I set the hostname and it
does not 'take'. On continue it does not display an X in front of the
networking option and once I do log in as root, the hostname is still
localhost. I can change the hostname with the normal commands.
What version of u-boot? There was an issue that affected some
AllWinner A20 devices, make sure you're running 2017.09 rc4
Dah, I had to do was check the saved console session:
U-Boot SPL 2017.09-rc2 (Aug 25 2017 - 17:20:07)
DRAM: 1024 MiB
CPU: 912000000Hz, AXI/AHB/APB: 3/2/2
Trying to boot from MMC1
U-Boot 2017.09-rc2 (Aug 25 2017 - 17:20:07 +0000) Allwinner Technology
CPU: Allwinner A20 (SUN7I)
[rgm@lx120e arm]$ head screenlog.6bad -n20
�
U-Boot SPL 2017.09-rc2 (Aug 25 2017 - 17:20:07)
DRAM: 1024 MiB
CPU: 912000000Hz, AXI/AHB/APB: 3/2/2
Trying to boot from MMC1
U-Boot 2017.09-rc2 (Aug 25 2017 - 17:20:07 +0000) Allwinner Technology
CPU: Allwinner A20 (SUN7I)
Model: Cubietech Cubieboard2
I2C: ready
DRAM: 1 GiB
MMC: SUNXI SD/MMC: 0
So Koji is building the image with RC2. Please point me to RC4 and I
will test with that. Or please roll RC4 into the build process.
I plugged in the TP-link USB wifi dongle, and the console went crazy
scrolling messages. I had to unplug the dongle. The last few messages are:
[ 6040.341864] usb 4-1: ath9k_htc: USB layer deinitialized
You need to include the full trace (from the point it says begin trace
or similar), but that's not really a ARM/cubieboard specific crash
Since I am looking at the capture file...
um, the whole capture is 440KB. How do you want it...
Bob
_______________________________________________
arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx
