> -----Original Message----- > From: Peter Robinson [mailto:pbrobinson@xxxxxxxxx] > Sent: Monday, October 31, 2016 9:35 AM > To: Timothy Krantz <tkrantz@xxxxxxxxxxxxxxxxxx> > Cc: arm@xxxxxxxxxxxxxxxxxxxxxxx > Subject: Re: [fedora-arm] Re: Jetson TK1 and kernel 4.8 > > >> >> > > > > Mine has as of yet failed to boot on any of them. > >> >> > > > > >> >> > > > Mine is currently running 4.8.1-1.fc25 without issues, just > >> >> > > > upgrading it to the latest now to test that too. > >> >> > > > >> >> > > Was running 4.8.2-300.fc25.armv7hl+lpae, upgraded to > >> >> > > 4.8.4-301.fc25 without any issues. Could you post output of > >> >> > > your > >> failure? > >> >> > > > >> >> > > Paul > >> >> > >> >> You might have better luck with a more recent version of U-Boot. > >> >> I'm running U-Boot 2016.11-rc2 with 4.8.4-301.fc25 on sata. > >> >> > >> >> > >> > > >> > That made sense to me so I upgraded to the uboot that you are using > >> > but > >> same problem. > >> > >> Do you have any extra peripherals added like a mPCIe card, camera or > >> other such things or is it just the base board? What device do you > >> have the rootfs on? eMMC, SD or SATA? > >> > >> I have mine running as a bare device with the OS on the eMMC, I think > >> Paul might have the OS on a sata SSD. Just trying to work out what if > >> any differences there are here as there's not much that can be different. > >> > > > > Thanks Peter! > > > > Mine is yet another variation. It is a bare board with the boot partition on an > SD card and the root filesystem on an SSD. I left the original eMMC > untouched until I upgraded the uBoot. > > The u-boot is on SPI nand not the eMMC so I suspect then you didn't even > touch it. > > > The only thing other than the SDcard and the SSD is the serial console. > > > > Just for kicks I tried an LPAE kernel and the first time I booted it got some > kenel oops that I had not seen before but I was not logging the console output > so I turned on capture and tried again but have not seen that kernel oops > since. > > > > For some reason my board is not seeing the sata controller (or not getting it > initialized properly) on 4.7 and 4.8 kernels but does on 4.6.7. > > Is it pulled into the initrd? Do you see the driver with a "lsinitrd | grep ahci" > > > Tim Krantz > > Well when booting fails with 4.8.4-lape it finally drops into a Dracut command prompt with no lsinitrd But all I see in to console logs is about a half dozen of : tegra-ahci 70027000.sata: couldn't get PHY in node sata: -517 and that is the only reference to ahci In a good boot on 4.6.7 I do see the driver loaded with lsinitrd | grep ahci. Tim _______________________________________________ arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx