On 5/29/15 8:37 PM, Peter Robinson wrote: > On Sat, May 30, 2015 at 1:31 AM, Scott M. Jones <scott@xxxxxxxx> wrote: >> I'm running F22, LXDE spin, on a Beagleboard XM rev B, and if uptime is >> greater than about 15 minutes, I get this error repeatedly on shutdown >> (with increasing timestamps) and the board becomes unusable until reset. >> >> [ 3505.530151] [drm:omap_irq_handler [omapdrm]] *ERROR* gfx: errors: >> 00000040 >> >> I've also seen this happen when I tried to connect via x11vnc, even >> though lxdm and X are running and x11vnc starts OK. >> >> Also, I'm not getting any output on the HDMI port. I'm not getting any >> HDMI output on F21 (with kernel 4.x) either now, but at least I can >> connect via x11vnc (same setup I'm using on F22). >> >> Both were yum/dnf updated today. >> >> I did boot the reference Angstrom release with the board to make sure >> the HDMI cable and TV were OK, and they are just fine. F21 used to work >> a few months ago via the HDMI port. >> >> Any suggestions? > > Maybe try with a 4.1 kernel to see if the problem is improved/fixed there. > > http://koji.fedoraproject.org/koji/buildinfo?buildID=638858 The error handling is better with the new kernel, but unfortunately I'm getting the same error. I did see a traceback fly by. Does it help to have this or report this somewhere? I suspect it is a problem between the X server and kernel. If I disable lxdm and reboot first, I can shut down just fine with no errors even after some time has passed. -Scott _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
