On Sat, May 30, 2015 at 1:31 AM, Scott M. Jones <scott@xxxxxxxx> wrote: > I'm running F22, LXDE spin, on a Beagleboard XM rev B, and if uptime is > greater than about 15 minutes, I get this error repeatedly on shutdown > (with increasing timestamps) and the board becomes unusable until reset. > > [ 3505.530151] [drm:omap_irq_handler [omapdrm]] *ERROR* gfx: errors: > 00000040 > > I've also seen this happen when I tried to connect via x11vnc, even > though lxdm and X are running and x11vnc starts OK. > > Also, I'm not getting any output on the HDMI port. I'm not getting any > HDMI output on F21 (with kernel 4.x) either now, but at least I can > connect via x11vnc (same setup I'm using on F22). > > Both were yum/dnf updated today. > > I did boot the reference Angstrom release with the board to make sure > the HDMI cable and TV were OK, and they are just fine. F21 used to work > a few months ago via the HDMI port. > > Any suggestions? Maybe try with a 4.1 kernel to see if the problem is improved/fixed there. http://koji.fedoraproject.org/koji/buildinfo?buildID=638858 _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
