On Fri, Mar 21, 2014 at 7:10 AM, Clive Messer <clive.m.messer@xxxxxxxxx> wrote: > On Fri, 2014-03-21 at 11:25 +0000, Peter Robinson wrote: >> > Is there any expectation that original BeagleBone (white, not black) >> > should complete booting with F20 minimal image, >> > Fedora-Minimal-VFAT-armhfp-20-1-sda.raw. >> > >> > It craps out looking for the root partition.... >> > >> > [ OK ] Reached target Basic System. >> > [ 289.718630] dracut-initqueue[254]: Warning: Could not boot. >> > [ 289.799095] dracut-initqueue[254]: >> > Warning: /dev/disk/by-uuid/dd78a003-5028-4466-b966-c33d9fefff1a does not >> > exist >> > >> > .... which I figure is probably a result of .... >> > >> > [ 5.985745] localhost kernel: omap_hsmmc 48060000.mmc: unable to >> > select pin group >> > [ 5.986400] localhost kernel: omap_hsmmc 48060000.mmc: vmmc regulator >> > missing >> > [ 6.094935] localhost kernel: sr_init: platform driver register >> > failed for SR >> >> Maybe, or maybe something else missing, I keep poking it on occasion >> but I've not worked out what bit of glue we're missing. > > I admit I gave up too easily yesterday, built a Robert Nelson 3.12.13 > and got my F20 image going with that. After I got running, I did update > the Fedora kernel to current 3.13.6 and tried to boot that. Same > problem, mmc driver not loading. I'll try to get to the bottom of this > afternoon. I'll diff the fedora/RN kernel config and see if anything > jumps out. If not, I'll start looking at am3* dts/dtsi files.... > > Robert, if you're reading this, don't suppose you can point me in the > direction of where to start looking? ;) v3.13.x pretty much works out of the box, so no dts/dtsi changes are necessary.. I'd first start looking at make sure the mmc driver is setup: CONFIG_TI_EDMA=y CONFIG_DMA_ENGINE=y Regards, -- Robert Nelson http://www.rcn-ee.com/ _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
