On Fri, 2014-03-21 at 11:25 +0000, Peter Robinson wrote: > > Is there any expectation that original BeagleBone (white, not black) > > should complete booting with F20 minimal image, > > Fedora-Minimal-VFAT-armhfp-20-1-sda.raw. > > > > It craps out looking for the root partition.... > > > > [ OK ] Reached target Basic System. > > [ 289.718630] dracut-initqueue[254]: Warning: Could not boot. > > [ 289.799095] dracut-initqueue[254]: > > Warning: /dev/disk/by-uuid/dd78a003-5028-4466-b966-c33d9fefff1a does not > > exist > > > > .... which I figure is probably a result of .... > > > > [ 5.985745] localhost kernel: omap_hsmmc 48060000.mmc: unable to > > select pin group > > [ 5.986400] localhost kernel: omap_hsmmc 48060000.mmc: vmmc regulator > > missing > > [ 6.094935] localhost kernel: sr_init: platform driver register > > failed for SR > > Maybe, or maybe something else missing, I keep poking it on occasion > but I've not worked out what bit of glue we're missing. I admit I gave up too easily yesterday, built a Robert Nelson 3.12.13 and got my F20 image going with that. After I got running, I did update the Fedora kernel to current 3.13.6 and tried to boot that. Same problem, mmc driver not loading. I'll try to get to the bottom of this afternoon. I'll diff the fedora/RN kernel config and see if anything jumps out. If not, I'll start looking at am3* dts/dtsi files.... Robert, if you're reading this, don't suppose you can point me in the direction of where to start looking? ;) Regards Clive -- Clive Messer <clive.m.messer@xxxxxxxxx> _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
