On Wed, Dec 5, 2012 at 4:30 PM, Mark Langsdorf <mark.langsdorf@xxxxxxxxxxx> wrote: > On 12/04/2012 04:56 PM, Peter Robinson wrote: >>>> We might need to add the new calxeda sata module (this is booting off >>>> sata?) to the dracut include list. Remind me what the module name is >>>> and I'll cross check it. >>> >>> This is booting off SATA. The module name is sata-highbank. >> >> Can you try this dracut and regenerate the initrd >> >> http://arm.koji.fedoraproject.org/koji/taskinfo?taskID=1282787 > > Is there supposed to be an rpm I can download there? I don't see one. > What am I missing here? It's a scratch build task so you need to click on the arch (armv5tel / armv7) to get the rpms. >>> I don't have this problem when custom building 3.6 kernels for f17 & f18. >> >> But then I'm sure you build the sata kernel modules in and specifying >> Calxeda specifics as opposed to a generic unified kernel that is >> ultimately going to need to support 100s of devices from numerous >> SoCs. > > I always build the sata as a module. > > I should have said I don't have an issue when building 3.7-rcX, and I > use the same scripts and dracut there (with the generic unified kernel) > as I do when I'm building the stock 3.6 kernel. > > I'm not complaining, I'm just curious about the difference. Do you have the modules specified in a config like modprobe.conf or something? I'm not sure but I would love to find out. Peter _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
