Hi... I'm running RH AS 2.1 on a DELL 2650 with bcm5700 driver. On boot (w./out any module config), I get the following in /var/log/messages: May 22 17:08:58 systemname kernel: bcm5700: eth0 NIC Link is UP, 100 Mbps half duplex The switch port on the other end is set to 100MB Full duplex. I put the following in /etc/modules.conf and rebooted. Doing that causes the card to not come up at all (i.e. eth0: link is down). alias eth0 bcm5700 options eth0 line_speed=100 full_duplex=1 Is there something I'm missing? Thanks.... -- <>< ><> <>< ><> <>< ><> <>< ><> <>< ><> <>< Ken Kleiner System Manager Computer Science Department Umass Lowell voice : 978 934 3645 fax : 978 934 3551 cell : 603 930 5582 (emergencies only, please) ken@xxxxxxxxxx
