Only these 2 entries in /etc/iscsi.conf DiscoveryAddress=192.168.0.119:3260 TargetName=iqn.1987-05.com.cisco.00.c9564bfc19bb80c0d168338aa9199d34.tar get_netapp1 Also my target replies with headerdigest=no, datadigest=no as I checked in login-response. DO I still need the crypto modules in installation phase. I can build them and load them through floppy ? Is there a way in anaconda installer to enable the crypto modules? -vikas -----Original Message----- From: Mike Christie [mailto:michaelc@xxxxxxxxxxx] Sent: Monday, October 17, 2005 3:51 PM To: Aggarwal, VikasX Cc: anaconda-devel-list@xxxxxxxxxx Subject: Re: "Cannot allocate memory" Aggarwal, VikasX wrote: > I have built an iSCSI driver update disk as I need to read iSCSI disk > during installation. > install to a iscsi disk is really not supported like this, so I am not sure what is available at install time. > But when my daemon tries to do ioctl to driver it gets "Cannot > allocate memory" > Normally during a light load like this is, it is becuase you do not have a crypto module loaded (they return ENOMEM when if it is not loaded). Send me your iscsi.conf file.
