recording with usb microphone Umik-1 on Debian and Raspberry Pi

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Team,

I am trying to record with alsa and Umik-1 (http://www.minidsp.com/products/acoustic-measurement/umik-1) on Debian and Raspbian (on Raspberry Pi hardware).
in both cases, I am experiencing the following:

- "lsusb" displays: [Bus 001 Device 005: ID 2752:0007]
- "amixer" and "arecord -l -L" can see the device and i can adjust the capture level as well.
- but recording with "arecord" does not happen. the recording starts, but no input is detected.

pls see the attached log on each of the above steps.
with same steps i was able to record with a "Samson C01u" microphone.
kindly advise on troubleshooting or any possible next steps.

thank you in advance,
regards,
zoltan

----------------------------------------------------------------------
root@raspberrypi:~# lsusb
Bus 001 Device 002: ID 0424:9512 Standard Microsystems Corp. 
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp. 
Bus 001 Device 005: ID 2752:0007  
----------------------------------------------------------------------
root@raspberrypi:~# arecord -l
**** List of CAPTURE Hardware Devices ****
card 1: U12dB [Umik-1  Gain: 12dB], device 0: USB Audio [USB Audio]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
----------------------------------------------------------------------
root@raspberrypi:~# arecord -L
null
    Discard all samples (playback) or generate zero samples (capture)
default:CARD=U12dB
    Umik-1  Gain: 12dB, USB Audio
    Default Audio Device
sysdefault:CARD=U12dB
    Umik-1  Gain: 12dB, USB Audio
    Default Audio Device
front:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    Front speakers
surround40:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    4.0 Surround output to Front and Rear speakers
surround41:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    4.1 Surround output to Front, Rear and Subwoofer speakers
surround50:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    5.0 Surround output to Front, Center and Rear speakers
surround51:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    5.1 Surround output to Front, Center, Rear and Subwoofer speakers
surround71:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    7.1 Surround output to Front, Center, Side, Rear and Woofer speakers
iec958:CARD=U12dB,DEV=0
    Umik-1  Gain: 12dB, USB Audio
    IEC958 (S/PDIF) Digital Audio Output
----------------------------------------------------------------------
root@raspberrypi:~# amixer -c 1 set Mic Capture 100%
Simple mixer control 'Mic',0
  Capabilities: cvolume cswitch cswitch-joined penum
  Capture channels: Front Left - Front Right
  Limits: Capture 0 - 55
  Front Left: Capture 55 [100%] [24.00dB] [on]
  Front Right: Capture 55 [100%] [24.00dB] [on]
----------------------------------------------------------------------
root@raspberrypi:~# amixer -c 1 set Mic Capture cap
Simple mixer control 'Mic',0
  Capabilities: cvolume cswitch cswitch-joined penum
  Capture channels: Front Left - Front Right
  Limits: Capture 0 - 55
  Front Left: Capture 55 [100%] [24.00dB] [on]
  Front Right: Capture 55 [100%] [24.00dB] [on]
----------------------------------------------------------------------
root@raspberrypi:~# arecord -vv -D default:CARD=U12dB -d 5 test.wav
Recording WAVE 'test.wav' : Unsigned 8 bit, Rate 8000 Hz, Mono
Plug PCM: Rate conversion PCM (48000, sformat=U8)
Converter: linear-interpolation
Protocol version: 10002
Its setup is:
  stream       : CAPTURE
  access       : RW_INTERLEAVED
  format       : U8
  subformat    : STD
  channels     : 1
  rate         : 8000
  exact rate   : 8000 (8000/1)
  msbits       : 8
  buffer_size  : 2730
  period_size  : 170
  period_time  : 21333
  tstamp_mode  : NONE
  period_step  : 1
  avail_min    : 170
  period_event : 0
  start_threshold  : 1
  stop_threshold   : 2730
  silence_threshold: 0
  silence_size : 0
  boundary     : 178913280
Slave: Route conversion PCM (sformat=S24_3LE)
  Transformation table:
    0 <- 0*0.5 + 1*0.5
Its setup is:
  stream       : CAPTURE
  access       : MMAP_INTERLEAVED
  format       : U8
  subformat    : STD
  channels     : 1
  rate         : 48000
  exact rate   : 48000 (48000/1)
  msbits       : 8
  buffer_size  : 16384
  period_size  : 1024
  period_time  : 21333
  tstamp_mode  : NONE
  period_step  : 1
  avail_min    : 1024
  period_event : 0
  start_threshold  : 6
  stop_threshold   : 16384
  silence_threshold: 0
  silence_size : 0
  boundary     : 1073741824
Slave: Direct Snoop PCM
Its setup is:
  stream       : CAPTURE
  access       : MMAP_INTERLEAVED
  format       : S24_3LE
  subformat    : STD
  channels     : 2
  rate         : 48000
  exact rate   : 48000 (48000/1)
  msbits       : 24
  buffer_size  : 16384
  period_size  : 1024
  period_time  : 21333
  tstamp_mode  : NONE
  period_step  : 1
  avail_min    : 1024
  period_event : 0
  start_threshold  : 6
  stop_threshold   : 16384
  silence_threshold: 0
  silence_size : 0
  boundary     : 1073741824
Hardware PCM card 1 'Umik-1  Gain: 12dB' device 0 subdevice 0
Its setup is:
  stream       : CAPTURE
  access       : MMAP_INTERLEAVED
  format       : S24_3LE
  subformat    : STD
  channels     : 2
  rate         : 48000
  exact rate   : 48000 (48000/1)
  msbits       : 24
  buffer_size  : 16384
  period_size  : 1024
  period_time  : 21333
  tstamp_mode  : ENABLE
  period_step  : 1
  avail_min    : 1024
  period_event : 0
  start_threshold  : 1
  stop_threshold   : 1073741824
  silence_threshold: 0
  silence_size : 0
  boundary     : 1073741824
  appl_ptr     : 0
  hw_ptr       : 0
#+                                                 | 00%
----------------------------------------------------------------------
root@raspberrypi:~# aplay -vv -D sysdefault:CARD=ALSA test.wav
Playing WAVE 'test.wav' : Unsigned 8 bit, Rate 8000 Hz, Mono
Plug PCM: Hardware PCM card 0 'bcm2835 ALSA' device 0 subdevice 0
Its setup is:
  stream       : PLAYBACK
  access       : RW_INTERLEAVED
  format       : U8
  subformat    : STD
  channels     : 1
  rate         : 8000
  exact rate   : 8000 (8000/1)
  msbits       : 8
  buffer_size  : 4000
  period_size  : 1024
  period_time  : 128000
  tstamp_mode  : NONE
  period_step  : 1
  avail_min    : 1024
  period_event : 0
  start_threshold  : 4000
  stop_threshold   : 4000
  silence_threshold: 0
  silence_size : 0
  boundary     : 2097152000
  appl_ptr     : 0
  hw_ptr       : 0
#+                                                 | 00%
----------------------------------------------------------------------
------------------------------------------------------------------------------
Flow-based real-time traffic analytics software. Cisco certified tool.
Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer
Customize your own dashboards, set traffic alerts and generate reports.
Network behavioral analysis & security monitoring. All-in-one tool.
http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk
_______________________________________________
Alsa-user mailing list
Alsa-user@xxxxxxxxxxxxxxxxxxxxx
https://lists.sourceforge.net/lists/listinfo/alsa-user

[Index of Archives]     [ALSA Devel]     [Linux Audio Users]     [Fedora Users]     [Fedora Desktop]     [Fedora SELinux]     [Big List of Linux Books]     [Yosemite News]     [Yosemite Photos]     [KDE Users]     [Fedora Tools]

  Powered by Linux