Hello list, I am the lucky owner of an Inspiron 9300 from Dell. It has a wonderful sound system with three speaker channels. My problem is, that the alsa-mixer has two master sliders: One called "Master Stereo" and one called "Master Mono". Okay big deal, you just slide them separately, but every desktop volume control will only change the "Master Stereo" and not the "Master Mono". Can I join them somehow? > $ cat /proc/asound/cards > 0 [ICH6 ]: ICH4 - Intel ICH6 > Intel ICH6 with STAC9750,51 at 0xdffffe00, irq 169 > $ cat /proc/asound/card0/codec97#0/ac97#0-0 > 0-0/0: SigmaTel STAC9750,51 > > PCI Subsys Vendor: 0x1028 > PCI Subsys Device: 0x0189 > > Capabilities : -headphone out- > DAC resolution : 20-bit > ADC resolution : 20-bit > 3D enhancement : SigmaTel 3D Enhancement > > Current setup > Mic gain : +0dB [+0dB] > POP path : pre 3D > Sim. stereo : off > 3D enhancement : off > Loudness : off > Mono output : MIX > Mic select : Mic1 > ADC/DAC loopback : off > Extended ID : codec=0 rev=1 AMAP DSA=0 SPDIF VRA > Extended status : SPCV SPDIF=3/4 VRA > PCM front DAC : 48000Hz > PCM ADC : 48000Hz > SPDIF Control : Consumer PCM Category=0x2 Generation=1 Rate=48kHz ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys - and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Alsa-user mailing list Alsa-user@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/alsa-user
