I installed Xfree86 without any problem - but after attempting to
autoconfigure, i received the following message:
A driver tried to allocate the block memsource at 0xa000:0xaffff
which conflicted with another resource.
hardware: 486 laptop - toshiba sattelite ti950ct with 8mb ram. (old,
but reliable)
i can't figure out how to open the log - any suggestions to correct this
problem so i can run autoconfigure again?
thanks,
kenneth
_______________________________________________
XFree86 mailing list
XFree86@xxxxxxxxxxx
http://XFree86.Org/mailman/listinfo/xfree86
