On Fri, 14 Jan 2005 13:03:13 +0800 (CST) fanxyz@xxxxxxxxx wrote: > linux: FC3 > kernel: 2.6.10 > XFree86: 4.4.0 > graphics card: ATI 9100 > > Please help me ~ > Thank you very much! > There are a lot of comments in your log file that say it's using the "built-in" configuration. This is probably not a good idea. If when you boot you are dropped straight to a text-based login prompt, then try the following: + Login as root + Run one of the following programmes: - xf86cfg - xf86config + Make sure you answer all questions as best you can. I can't remember which, but one of those programmes gives you a low-res GUI which you can use to configure your system. It takes a little getting used-to. + Try restarting your X system (as root, try typing "startx" (obviously without the " marks)). Grant. -- Artificial intelligence is no match for natural stupidity. _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
