Thank you Mark, it is AGP one. From Xfree86.log: (--) MGA(0): Chipset: "mgag200" (**) MGA(0): Depth 24, (--) framebuffer bpp 32 (==) MGA(0): RGB weight 888 (==) MGA(0): Using AGP 1x mode (--) MGA(0): Linear framebuffer at 0xE3000000 (--) MGA(0): MMIO registers at 0xE2000000 (--) MGA(0): Pseudo-DMA transfer window at 0xE1800000 cat /proc/mtrr: reg00: base=0x00000000 ( 0MB), size= 256MB: write-back, count=1 reg01: base=0xe3000000 (3632MB), size= 16MB: write-combining, count=3 Somewhat strange that count=3 but still the region looks correct to me. Any hints on what could be a bottleneck are appreciated. --- (Please CC me, I'm not subscribed to XFree86 ML) Best regards, Nikolai Zhubr Mark Vojkovich wrote: > That looks reasonable for a PCI card. If that's > an AGP card, that's low and you'll want to make sure > that mtrrs are setup correctly. /proc/mtrr should > show a write-combined region for the video ram. > > Mark. > > On Mon, 19 Jan 2004, Nikolai Zhubr wrote: > > Hi, > > could someone please point me what would be > > reasonable x11perf -shmput500 results for > > matrox G200 on P3-800? I'm using XFree 4.3.0 > > here and I get 85/sec. Is it the best G200 can > > do? > > Lots of thanks. > > (Please CC me, I'm not subscribed) > > --- > > Best regards, > > Nikolai Zhubr > > _______________________________________________ > > XFree86 mailing list > > XFree86@xxxxxxxxxxx > > http://XFree86.Org/mailman/listinfo/xfree86 _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86