You should give some info on your monitor which distribution you have and possibly post your XF86config... I myself have a G550 with a Samsung SyncMaster 181T which I drive with DVI and have few problems. I have a console login (just in case problems occur) and use startx, sometimes it takes a bit of time for X to come up and it has happened that I just canceled it and typed startx again it then started much faster... The problem may also be with the combination G550 / monitor because I have two similar setups (G550 + 181T) and on one of them the monitor must be switched off and on from time to time, it seems to lose the signal this as well with w2k as with Linux... cheers Lionel --- Meylan Paul-Louis <paul-louis.meylan@xxxxxxx> wrote: > Hey > > I have a PC with a matrox G550, the monitor is connected > to the DVI output and this configuration don't work > with Xfree86 4.3.0. > Where i can find the right driver for this card. > > Thanks > > -- > > Meylan Paul-Louis > > +------------------------------------------+ > | Meylan Paul-Louis | > | EPFL/I&C/LTI | > | Tel: +41 21.693.47.13 Fax: 66.00 | > +------------------------------------------+ > > > _______________________________________________ > XFree86 mailing list > XFree86@xxxxxxxxxxx > http://XFree86.Org/mailman/listinfo/xfree86 __________________________________ Do you Yahoo!? New Yahoo! Photos - easier uploading and sharing. http://photos.yahoo.com/ _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
