On Thu, 20 Apr 2017 16:30:34 +0200 Jesper Dangaard Brouer <brouer@xxxxxxxxxx> wrote: > On Wed, 19 Apr 2017 10:29:03 -0400 > Andy Gospodarek <andy@xxxxxxxxxxxxx> wrote: > > > I ran this on top of a card that uses the bnxt_en driver on a desktop > > class system with an i7-6700 CPU @ 3.40GHz, sending a single stream of > > UDP traffic with flow control disabled and saw the following (all stats > > in Million PPS). > > > > xdp1 xdp2 xdp_tx_tunnel > > Generic XDP 7.8 5.5 (1.3 actual) 4.6 (1.1 actual) > > Optimized XDP 11.7 9.7 4.6 > > > > One thing to note is that the Generic XDP case shows some different > > results for reported by the application vs actual (seen on the wire). I > > did not debug where the drops are happening and what counter needs to be > > incremented to note this -- I'll add that to my TODO list. The > > Optimized XDP case does not have a difference in reported vs actual > > frames on the wire. > > The reported application vs actual (seen on the wire) number sound scary. > How do you evaluate/measure "seen on the wire"? > > Perhaps you could use ethtool -S stats to see if anything is fishy? > I recommend using my tool[1] like: > > ~/git/network-testing/bin/ethtool_stats.pl --dev mlx5p2 --sec 2 > > [1] https://github.com/netoptimizer/network-testing/blob/master/bin/ethtool_stats.pl > > I'm evaluating this patch on a mlx5 NIC, and something is not right... > I'm seeing: > > Ethtool(mlx5p2) stat: 349599 ( 349,599) <= tx_multicast_phy /sec > Ethtool(mlx5p2) stat: 4940185 ( 4,940,185) <= tx_packets /sec > Ethtool(mlx5p2) stat: 349596 ( 349,596) <= tx_packets_phy /sec > [...] > Ethtool(mlx5p2) stat: 36898 ( 36,898) <= rx_cache_busy /sec > Ethtool(mlx5p2) stat: 36898 ( 36,898) <= rx_cache_full /sec > Ethtool(mlx5p2) stat: 4903287 ( 4,903,287) <= rx_cache_reuse /sec > Ethtool(mlx5p2) stat: 4940185 ( 4,940,185) <= rx_csum_complete /sec > Ethtool(mlx5p2) stat: 4940185 ( 4,940,185) <= rx_packets /sec > > Something is wrong... when I tcpdump on the generator machine, I see > garbled packets with IPv6 multicast addresses. > > And it looks like I'm only sending 349,596 tx_packets_phy/sec on the "wire". > Not seeing packets on the TX wire was caused by the NIC HW dropping the packets, because the ethernet MAC-addr were not changed/swapped. Fixed this XDP_TX bug in my test program xdp_bench01_mem_access_cost. https://github.com/netoptimizer/prototype-kernel/commit/85f7ba2f0ea2 Even added a new option --swapmac for creating another test option for modifying the packet. https://github.com/netoptimizer/prototype-kernel/commit/fe080e6f3ccf I will shortly publish a full report of testing this patch. -- Best regards, Jesper Dangaard Brouer MSc.CS, Principal Kernel Engineer at Red Hat LinkedIn: http://www.linkedin.com/in/brouer
|