opensuse 11.2 64 bit I have downloaded and compiled/installed wine 1.1.11, so that I may use a windows program called WinMX 3.54b4 [32 bit] on my linux opensuse distro. I had been advised that Wine versions higher than this do not work well with WinMX. At the end of the compile it tells me that libgphoto2-32bit was not found and that cameras won't work. I check in Yast2 to see if it can be installed and find that it is installed. I uninstall and reinstall it and run the compile again but it still tells me that it is not installed. I am not planning on using any windows camera software, so I ignore it and carry on with the make and make install. Wine is finished and I navigate to a browser [firefox] so that I can downloadl my WinMX from a website and install it. I install winmx thru wine and it goes fine up until the 1st start instance of winmx. All of a sudden I get a popup window [Wine Gecko Installer] informing me that my application is trying to show an html page, [WinMX is a P2P music and chat program][listed on this site] and that wine needs gecko to do this. Click Install to do this. So if I click install it just hangs and nothing happens. If I click cancel, Winmx opens and does its thing. I have done some googling and came up with this info: http://ubuntuforums.org/archive/index.php/t-332962.html I went thru the steps and still nothing changed. Did a little more digging on WineHQ site and found I needed a different version of gecko for The version of wine I am using. Went thru steps again, but still this window pops up and hangs when I click the install button. How can I get this gecko to either install or go away. I have not had any of this happen before and I have installed and also complied a few different versions of wine and the gecko thing always was ok before too. Is it because I am compiling a 32 bit wine on a 64 bit system? I followed the directions for this very closely and had no problems before re: dependencies, etc. The prior versions that I installed on this 64 bit system are version 1.0 and version 1.2. I had no problems and they worked fine. I cannot figure out what I am doing differently or wrong. Please help. Thank You.
