vitamin wrote: > http://www.winehq.org/docs/wineusr-guide/misc-things-to-configure#AEN407 hmm.... that doesn't yet seem to do the trick...here is my status linux-zatr: # lspci -vv -s 7:00.0 07:00.0 Serial controller: NetMos Technology PCI 9820 Multi-I/O Controller (rev 01) (prog-if 02 [16550]) Subsystem: LSI Logic / Symbios Logic Device 0001 Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Interrupt: pin A routed to IRQ 16 Region 0: I/O ports at 2010 [size=8] Region 1: I/O ports at 2018 [size=8] Region 2: I/O ports at 2020 [size=8] Region 3: I/O ports at 2028 [size=8] Region 4: I/O ports at 2030 [size=8] Region 5: I/O ports at 2000 [size=16] Kernel driver in use: serial linux-zatr: # setserial /dev/ttyS0 -a /dev/ttyS0, Line 0, UART: 16550A, Port: 0x2010, IRQ: 16 Baud_base: 11520, close_delay: 50, divisor: 0 closing_wait: 3000 Flags: spd_normal skip_test ...and I have set a link from ttyS0 to com1 in dosdevices... Any ideas?
