Don, That's still an RPM. Look for the link that takes you to sourceforge and download the wine-20041019.tar.bz2 file. This is distro neutral. build instructions aren't too much more than: (from memory) [As user bunzip2 wine-20041019.tar.bz2 tar xvf wine-20041019.tar cd wine ./autogen.sh (may not be necessary) ./configure --prefix=/usr make [As root] make install And then as user run your wine setup and wine programs. This much should at least get it installed. Whether it actually works for you is another story... ;-) - Mark On Thu, 02 Dec 2004 12:43:05 -0500, Don Flinn <flinn@xxxxxxxxxxxx> wrote: > Mark > > Thanks for the quick reply. That sounds like good advice and I'll get > on it. One additional concern. The source is listed as fc2 also, > wine-20041019-1fc2winehq.src.rpm . > > Don > > > > On Thu, 2004-12-02 at 08:09 -0800, Mark Knecht wrote: > > No, I would not try that. It would be better if you downloaded source > > code and built it from scratch in this case. While it may be a little > > tough for a new Linux person to build such a big program I think > > you'll learn a bit and have a better chance of wine working correctly > > for you. > > > > You can download the official release by following links on the front > > page of the WineHQ web site. > > > > > > On Thu, 02 Dec 2004 10:31:49 -0500, Don Flinn <flinn@xxxxxxxxxxxx> wrote: > > > Hi > > > > > > I am running Fedora Core 3. Since there is no wine distro for core 3 is > > > it ok to run the distro for core 2 and/or are there any caveats? > > > > > > Don > > > > > > _______________________________________________ > > > wine-users mailing list > > > wine-users@xxxxxxxxxx > > > http://www.winehq.org/mailman/listinfo/wine-users > > > > > > > _______________________________________________ wine-users mailing list wine-users@xxxxxxxxxx http://www.winehq.org/mailman/listinfo/wine-users
