Hi,
I am trying to configure vlans on my CentOS 4.5 box. I am able to create
a vlan on eth1
eth1 is up but no IP address
eth1.2 is a vlan interface with address 10.0.0.78 that has set a route
for 10.0.0.72/255.255.255.248 (shows up in the routing table)
no iptables or other packet filtering mechanism for the moment
interface connected to a Dell PowerConnect 6248 to a port that is in a
configured VLAN on the switch consisting of four switchports. Two hosts
are connected to the same VLAN on the switch, having IP addresses
10.0.0.77 and 10.0.0.76.
If I destroy the vlan on the Linux box and set 10.0.0.78 directly on the
NIC I can reach both 10.0.0.77 and 10.0.0.76. If i try to route through
the vlan as described above I cannot. Tcpdump while pinging shows arp
requests on the vlan interface. The eth1 nic is a Broadcom Corporation
NetXtreme II BCM5708. Kernel is 2.6.9-55.ELsmp from RedHat rebuilt by
CentOS.
Can anybody provide me with a hint?
Thanks,
Arjen Van Drie.
_______________________________________________
Vlan mailing list
Vlan@xxxxxxxxxxxxxxx
http://www.candelatech.com/mailman/listinfo/vlan
