Hi all,
I try to emulate vlan setup with this setup
PC-A -? on vlan2 eth0-0.0.0.0 & eth0.2-192.168.127.141
PC-C -? on vlan3 eth0-0.0.0.0 & eth0.3-192.168.128.141
PC C acting as vlan router
eth1-0.0.0.0 eth1.2-192.168.127.142
eth2 -0.0.0.0 eth2.3-192.168.128.142
VLAN2 eth2 VLAN3 eth3
PC A ----------------------> PC B ----------------------> PC C
I was able to ping from a to b and from c to b but not a->c & c->a. also when I analyzed pkt in ethereal I found no vlan tag att to pkt.
I?m dumping the output of route and ifconfig.
The routing info & ifconfig at B is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.128.0 * 255.255.255.0 U 0 0 0 eth2.3
192.168.127.0 * 255.255.255.0 U 0 0 0 eth1.2
192.168.144.0 * 255.255.254.0 U 0 0 0 eth0
default 192.168.144.5 0.0.0.0 UG 0 0 0 eth0
ifconfig-
eth0 Link encap:Ethernet HWaddr 00:07:E9:09:D7:79
inet addr:192.168.144.142 Bcast:192.168.145.255 Mask:255.255.254.0
inet6 addr: fe80::207:e9ff:fe09:d779/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:68255 errors:0 dropped:0 overruns:0 frame:0
TX packets:1599 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:6391334 (6.0 MiB) TX bytes:198958 (194.2 KiB)
Base address:0xdec0 Memory:fe960000-fe980000
eth1 Link encap:Ethernet HWaddr 00:07:E9:09:D5:63
inet6 addr: fe80::207:e9ff:fe09:d563/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:35 errors:0 dropped:0 overruns:0 frame:0
TX packets:69 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3584 (3.5 KiB) TX bytes:6034 (5.8 KiB)
Base address:0xdf00 Memory:fe9a0000-fe9c0000
eth1.2 Link encap:Ethernet HWaddr 00:07:E9:09:D5:63
inet addr:192.168.127.142 Bcast:192.168.127.255 Mask:255.255.255.0
inet6 addr: fe80::207:e9ff:fe09:d563/64 Scope:Link
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:35 errors:0 dropped:0 overruns:0 frame:0
TX packets:45 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2814 (2.7 KiB) TX bytes:3862 (3.7 KiB)
eth2 Link encap:Ethernet HWaddr 00:0D:56:D9:22:24
inet6 addr: fe80::20d:56ff:fed9:2224/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:54 errors:0 dropped:0 overruns:0 frame:0
TX packets:60 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:4016 (3.9 KiB) TX bytes:4754 (4.6 KiB)
Base address:0xdf40 Memory:fe9e0000-fea00000
eth2.3 Link encap:Ethernet HWaddr 00:0D:56:D9:22:24
inet addr:192.168.128.142 Bcast:192.168.128.255 Mask:255.255.255.0
inet6 addr: fe80::20d:56ff:fed9:2224/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:28 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1680 (1.6 KiB) TX bytes:1776 (1.7 KiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:1932 errors:0 dropped:0 overruns:0 frame:0
TX packets:1932 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2546953 (2.4 MiB) TX bytes:2546953 (2.4 MiB)
And at a is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.128.0 * 255.255.255.0 U 0 0 0 eth0.2
And at b is
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.127.0 * 255.255.255.0 U 0 0 0 eth0.3
I have devoted 2 days but I'm not able to figure out the problem. What is going wrong?? Please direct me where I?m doing mistake.
Thanks ?
Sunil Parolia
________________________________________
From: vlan-bounces@xxxxxxxxxxxxxxx [mailto:vlan-bounces@xxxxxxxxxxxxxxx] On Behalf Of hareram
Sent: Monday, April 11, 2005 5:20 PM
To: vlan@xxxxxxxxxxxxxxx
Subject: Re: [VLAN] linux box as vlan router
Hi
?
yes you can do that with out any effort
if you are newly installing, install selecing all packages
so its installs automatically.
?
vconfig package for adding vlans
?
this link may help you
?
http://www.planetconnect.com/vlan/
?
hare
----- Original Message -----
From: Sunil Parolia
To: vlan@xxxxxxxxxxxxxxx
Sent: Monday, April 11, 2005 11:08 AM
Subject: [VLAN] linux box as vlan router
Hi I'm new to vlan. This q may sound absurd, but just wanted to know can we configure standard linux box as vlan router? If yes can anybody direct to relevant site for configuration? I'm using fedora-3 with kernel version of 2.6.9-1.667
Thanks & regards,
Sunil Parolia
________________________________________
_______________________________________________
Vlan mailing list
Vlan@xxxxxxxxxxxxxxx
http://www.lanforge.com/mailman/listinfo/vlan
