I found solution.
I just need to run
sudo ln -s /usr/share/qemu-linaro/qemu/keymaps/ /usr/share/qemu/keymaps
By some reasons keymaps dir is located in wrong place.
After that VirtManager just works.
2013/8/29 Michal Privoznik <mprivozn@xxxxxxxxxx>
On 29.08.2013 08:02, Martin Kletzander wrote:In fact, the path is /var/log/libvirt/<hypervisor>/<machine_name>.log
> On 08/29/2013 12:07 AM, Vadim Bartko wrote:
>> hi,
>>
>>
>> I am trying to run Virt Manager and every time during VM creation i get
>> these two errors:
>>
>> 1. (for kvm):
>>
>> libvirtError: Unable to read from monitor: Connection reset by peer
>>
>> 2. (for qemu):
>>
>> Unable to complete install: 'internal error process exited while connecting
>> to monitor: char device redirected to /dev/pts/2 (label charserial0)
>> Could not read keymap file: 'en-us
>>
>
> These both just mean that qemu died while libvirt was trying to
> communicate with it.
>
> What are your libvirt/qemu versions? Can you check
> /var/log/libvirt/<machine_name>.log file to see what's in there? If
Since in this specific case hypervisor = "qemu", the path would be:
/var/log/libvirt/qemu/<machine_name>.log
Or http://wiki.libvirt.org/page/DebugLogs
> there's nothing relevant, I suggest enabling debugging [1], reproducing
> and going through the logs again.
>
> Martin
>
> [1] http://libvirt.org/logging.html
Michal
Best regards,
Vadim Bartko
skype: hudvin
email: hudvin@xxxxxxxxx
mobile: +380994334484
_______________________________________________ virt-tools-list mailing list virt-tools-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/virt-tools-list
