Am Sonntag, den 18.03.2018, 23:29 +0100 schrieb Klaus Schmidinger:
> On 18.03.2018 20:39, Oliver Endriss wrote:
> > Am Sonntag, den 18.03.2018, 19:15 +0100 schrieb Klaus Schmidinger:
> >> On 18.03.2018 18:55, Oliver Endriss wrote:
> >> > Hi,
> >> >
> >> > just installed vdr 2.3.9 and noticed that there is a delay
> >> > when I try to set a recording mark, compared with vdr 2.2.0.
> >> >
> >> > Steps to reproduce:
> >> > - Play a recording.
> >> > - Press ok to display the progress bar.
> >> > - Press 0 to set a mark.
> >> >
> >> > There is a notable delay between the keypress
> >> > and the mark showing up.
> >> >
> >> > Can someone confirm this?
> >>
> >> Tried it while replaying on a Raspberry Pi, with the video directory
> >> mounted via NFS, and had no unusual delay.
> >>
> >> - Which skin are you using?
> > Classic skin.
> >
> >> - If applicable: Does it also happen with the LCARS skin?
> > Yes.
> >
> >> - Are you running any plugins that utilize the cStatus::MarksModified() function?
> > No. Test setup: vdr + dvbsddevice + remote.
>
> I'm afraid I don't have a working VDR with the old FF card any more, so
> I can't test on that hardware. It doesn't happen with the Raspberry Pi, though.
>
> Does it make a difference whether the progress display is active or not
> when you set the mark?
>
> >> - If none of the above: can you determine which version between 2.2.0 and
> >> 2.3.9 introduced this?
> >
> > Ok. I went back in time and installed the older versions.
> > Problem appeared with vdr-2.3.2, vdr-2.3.1 tested ok.
>
> The only change that was introduced in that area between these two versions
> is in cReplayControl::ShowProgress():
>
> if (Initial || time(NULL) - lastProgressUpdate >= 1) {
>
> Please try commenting out that line and the corresponding closing '}'.
> While I don't see why this would only be a problem on dvbsddevice and not
> on rpihddevice, I strongly suspect it to be the culprit.
Yes, this fixes the issue completely!
In vdr-2.3.9 the line looks like
if (Initial || lastSpeed != -1 || time(NULL) - lastProgressUpdate >= 1)
As a consequence, the mark shows up immediately during fast-forward,
while it is displayed with (variable) delay in play mode.
In vdr-2.3.2, "lastSpeed != -1" is missing, so fast-forward
is affected, too.
Anyway, I do not understand why rpihddevice should behave differently.
Does this device have a slow OSD? In this case you might not notice...
I will update my dvbhddevice vdr to vdr-2.3.9 soon.
I expect that it affected the same way.
Oliver
--
----------------------------------------------------------------
VDR Remote Plugin 0.7.0: http://www.escape-edv.de/endriss/vdr/
4 MByte Mod: http://www.escape-edv.de/endriss/dvb-mem-mod/
Full-TS Mod: http://www.escape-edv.de/endriss/dvb-full-ts-mod/
----------------------------------------------------------------
_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
https://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
