Any ideas or suggestions from anyone?
When I switch to any live SD channel, I only get 3 seconds of audio/video
and then then "channel not available". A few seconds later the picture
comes back, for another 3 seconds, then unavailable.
Jul 25 10:39:46 localhost vdr: [2499] switching to channel 1
Jul 25 10:39:46 localhost vdr: [2532] receiver on device 1 thread started
(pid=2499, tid=2532)
Jul 25 10:39:46 localhost vdr: [2533] TS buffer on device 1 thread
started
(pid=2499, tid=2533)
Jul 25 10:39:48 localhost vdr: [2532] cVideoRepacker: switching to
MPEG1/2
mode
Jul 25 10:39:48 localhost vdr: [2532] cVideoRepacker: operating in
MPEG1/2
mode
Jul 25 10:39:50 localhost vdr: [2533] TS buffer on device 1 thread ended
(pid=2499, tid=2533)
Jul 25 10:39:50 localhost vdr: [2532] buffer stats: 201536 (9%) used
Jul 25 10:39:50 localhost vdr: [2532] receiver on device 1 thread ended
(pid=2499, tid=2532)
Jul 25 10:39:57 localhost vdr: [2499] switching to channel 1
Jul 25 10:39:57 localhost vdr: [2499] info: Channel not available!
Jul 25 10:41:18 localhost vdr: [2499] switching to channel 1
Jul 25 10:41:18 localhost vdr: [2535] receiver on device 1 thread started
(pid=2499, tid=2535)
Jul 25 10:41:18 localhost vdr: [2536] TS buffer on device 1 thread
started
(pid=2499, tid=2536)
Jul 25 10:41:19 localhost vdr: [2535] cVideoRepacker: switching to
MPEG1/2
mode
Jul 25 10:41:19 localhost vdr: [2535] cVideoRepacker: operating in
MPEG1/2
mode
Jul 25 10:41:22 localhost vdr: [2536] TS buffer on device 1 thread ended
(pid=2499, tid=2536)
Jul 25 10:41:22 localhost vdr: [2535] buffer stats: 282564 (13%) used
Jul 25 10:41:22 localhost vdr: [2535] receiver on device 1 thread ended
(pid=2499, tid=2535)
Jul 25 10:41:29 localhost vdr: [2499] switching to channel 1
Jul 25 10:41:29 localhost vdr: [2499] info: Channel not available!
The same setup works fine under vdr-1.6.0.
Incidentally, I tried the attached patch for vdr-xine and the VPID issue,
but it had no effect.
Also tried recording a channel via skincurses without xine-ui attached,
but
still get the above errors and corresponding console messages:
SetPlayMode: 1
SetPlayMode: 0
Is there more debugging I can turn on? Why am I getting the "receiver on
device 1 thread ended" ?
Thanks
Simon
--------------------------------------------------------------------------------
_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
