> In the bugtracker you'll find a patch which makes streamdev compile again. It > comments out the PES output stuff which causes the problems until a clean > solution is available. > > http://www.vdr-developer.org/mantisbt/view.php?id=506 Thanks, I applied that patch and streamdev build then fine for vdr-1.7.3 Here are my test results. (5 days old s2-liplianin, hvr-1300 for dvb-t and hvr-4000 for dvb-s/s2) 1) Watching and switching between DVB-T channels (both withing same mux or different muxes) worked ok just by giving commands like mplayer http://localhost:3000/TS/1 mplayer http://localhost:3000/TS/3 2) Watching of DVB-S and DVB-S2 worked most of the times if I did it in the following sequence - close vdr-1.7.3 - switch to dvb-s/dvb-s2 channel for example by using ./szap-s2/szap-s2 -a 1 -S 2 -c channels.conf arteHD - close szap-s2 with ctrl-c - launch vdr-1.7.3 - open same channel that was earlier szapped: mplayer http://localhost:3000/TS/6 If I did not pre-tuned s/s2 channel I wanted to watchfirst with szap, mplayer just showed in console: Connecting to server localhost[127.0.0.1]: 3000... Cache size set to 320 KBytes Cache fill: 0.00% (0 bytes) Sometimes I also needed to use szap-s2 multiple times for being able to watch s2 channels. On those failing cases mplayer showed Cache fill: 0.00% (0 bytes) TS file format detected. VIDEO MPEG2(pid=6210) AUDIO MPA(pid=6221) NO SUBS (yet)! PROGRAM N. 0 Stream not seekable! Mika _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
