This probably isn't anyhow related to this thread but I get following messages in dmesg output: vdr-fbfe[21775]: segfault at 000004d0 eip b7207719 esp bfd4c9e0 error 4 vdr-fbfe[22134]: segfault at 000004d0 eip b720a719 esp bfcfa190 error 4 It's not a big problem as it's only related to exiting the frontend either with keyboard ESC or killall vdr-sxfe. It's the yesterday's cvs version. I can't say when did it start. -Kimmo On 08 May 2008, at 11:07, Petri Helin wrote: > Graziano Pavone wrote: >> >> >> 2008/5/7 Petri Helin <phelin@xxxxxxxxxxxxxx <mailto:phelin@xxxxxxxxxxxxxx >> >>: >> >> >> Could you update xineliboutput from the cvs and try again? In >> case you >> still see the same behaviour, attach your setup.conf (or just the >> xineliboutput subset) and ~/.xine/config_xineliboutput and tell >> the >> exact command you use to start vdr-sxfe. >> >> For your information, I use vdr-sxfe with the current cvs and I >> don't >> experience any problems with cropping. >> >> -Petri >> >> >> I will try with the CVS version, anyway I don't think it's >> xineliboutput >> fault, since it's working on the main PC (also with crop enabled). >> I suspect it's some dependencies missing on the client... >> >> > > The obvious one to check is that you have the autocrop post plugin in > place: ls `xine-config --plugindir`/post/xineplug_post_autocrop.so > > You could start vdr-sxfe with argument "--verbose" and see if there > are > any complaints in the output. > > -Petri > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
