Morfsta wrote: >> Is there a way to use more than a card with it when only one is DVB-S2 >> capable ? > > I just dropped a mail to Reinhard asking the same question. My > "production" system runs 2 DVB-T cards that currently don't work with > vdr-1.5.12 / multiproto. I would love to start using it full time but > until I can get support for DVB-T then it won't be possible. > > There's two ways you can do this I believe, port the dvb-t driver > properly to the new multiproto tree or modify VDR to fall back to the > old interface to tune the driver if the new one fails. > > I know that it is possible to use the old interface because when I use > vdr-1.4.7 with the multiproto tree it works fine for DVB-T, however I > am not sure where to start coding this into either VDR and I'm not > sure my skills are that hot at the driver level! > > If someone could provide some pointers here, that would be great (Manu > or Reinhard?) Over here, tests were done on STB0899, STV0299 and TDA10021 based all work out of the same multiproto tree (http://jusst.de.hg/multiproto) Regards, Manu _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
