Have you tried ethtool to setup WoL options? I run "ethtool -s eth0 wol pg". - Kimmo _____ Alkuper?inen viesti _____ Aihe: [vdr] Wakeup On LAN Tekij?: "Bernd Juraschek" <vdr@xxxxxxxxxxxxx> P?iv?m??r?: 3. maaliskuuta 2007 1:18:32 Hello, I'm trying to wakeup my Siemens Scaleo-T using WOL - but without success :-( The PC to wakeup: - Siemens Scaleo-T AMD64 with Onboard LAN (Tulip chip) - Linux 2.6.20 with ACPI enabled - Gentoo amd64 The router: - ASUS WL-500g Deluxe - OpenWrt White Russian - With X-Wrt Extensions RC6 - WOL-Software: wol What I've done: - BIOS: Wakeup controlled by BIOS and WOL enabled - Gentoo: echo -n PCI0 > /proc/acpi/wakeup ; halt - Router: wol -h PC-IP-Addr PC-MAC-Addr I've configured the router to start wol periodically. On the PC wireshark is now showing incoming UDP packets to the UDP port 40000. The packet contains the ethernet frame, the IP header, the UDP header and the magic data (6x 0xff and 16x MAC-Addr). It seems all ok - but the PC will not be started. What's going wrong? Should I use some ACPI sleep mode? Is this supported by the DVB drivers? Is the Siemens PC not usable for WOL? Thanks for help, Bernd -- Obwohl das Weltall expandiert, findet man nirgendwo Parkpl??tze. -- BR Space night _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.linuxtv.org/pipermail/vdr/attachments/20070303/a2d2bfc2/attachment.htm
