Hi there, I picked up a Skystar2 Air2Pc card. I've tried to scan for channels with it (Rogers Cable in Canada) with no success using the dvbapps atscscan tool. I seem to just get alot of timeouts. I'm not sure how to get a scan of available channels from this card. I've tried using a list of freq I found somewhere online: A 525000000 QAM256 A 579000000 QAM256 A 597000000 QAM256 A 657000000 QAM256 A 681000000 QAM256 A 699000000 QAM256 A 771000000 QAM256 A 837000000 QAM256 A 843000000 QAM256 I'm not certain these are even correct. I don't get anything with them either. I've tried each of the standard files with the same results. I found a one line example from a channels file, and it looks like azap locks to the channel so I *think* its working. My dmesg output is: b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully flexcop-pci: will use the HW PID filter. flexcop-pci: card revision 2 DVB: registering new adapter (FlexCop Digital TV device). b2c2-flexcop: MAC address = 00:d0:d7:30:1a:8c b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121) Unknown/Unsupported NXT chip: 00 00 00 00 00 b2c2-flexcop: i2c master_xfer failed lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121) bcm3510: Revision: 0x1, Layer: 0xb. b2c2-flexcop: found the bcm3510 at i2c address: 0x0f DVB: registering frontend 0 (Broadcom BCM3510 VSB/QAM frontend)... b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 1st generation' at the 'PCI' bus controlled by a 'FlexCopIIb' complete I'm not certain if this is correct -- are there module options I should be using to make sure I get the correct frontend? An example or a channels.conf file would be appreciated too but any advice please. Thanks Norm -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.linuxtv.org/pipermail/vdr/attachments/20060811/cbc93857/attachment.htm
