On Tue, 1 Nov 2005, Andre Bischof wrote: > Thus I experimented with the horizontal Offset, but neither -50 nor +50 > helps, I think I had to use something about 240 pixels, which extends the > possible maximum of +/-50. The horizontal offset is intended only for minor tweaking and normally it should be very close to zero. > Below are the settings regarding to femon from my setup.conf, and further > below the complete setup.conf - maybe someone could have a look 'cause I > think it might be a matter of misconfiguration? That would be very nice > indeed! Just tried your settings and the whole OSD was shown (although not centered because of your offset setting -50). No problems here! > I'm using vdr-1.3.31, nova-t + dxr3 (adv-chip). As I mentioned before, this > is no problem with all OSD's but only when using femon-0.9.1 I'm using FF-card here (vdr-1.3.35, femon-0.9.5pre), so the problem might be related to DXR3 and OpenRaw() method... my advise is to uninstall the femon plugin and all your problems are gone :) BR, -- rofa
