Hi, I installed the splitter, and it worked for me too - great! Previously, when I used skystar module, which came along with gentoo kernel, I tried that splitter, but it did not work. These new CVS drivers seem to work. _______ BR, Voitto Andreas Mueller kirjoitti 02.08.2005 kello 11:21: > voitto.tuomainen@xxxxxxxxx wrote: > > Hi, > > I have following system: > > - two Technisat Airstar2 PCI card (budget cards) > > - one Technisat Skystar2 (budget card) > > - Sapphire Radeon 9600 XT > > - Sempron 2800+ > > - ASUS motherboard > > - gentoo (updated to half a week old snapshot) > > - kernel 2.6.12-gentoo-r6 > > - udev 064 > > - vdr 1.3.27 > > -- softdevice cvs (31.7.) > > > > I feed input of the second card from output of the first, to which > > input I feed the terrestial antenna signal. If I feed output of the > > second card to TV, I get proper picture as long as the computer is > > on. > > > > My problem is that while I record one program, and change channel to > > another, which is not in the same channel transponder (?/multiplexer) > > as the one is recorded, I get the error: device 3 has no lock, can't > > attach receiver. > > I've had a similar problem with two AirStar2 PCI cards, the output of > the first card was connected to the input of the second card. However, > the card's output seems to have a problem with the 5 Volts remote power > supply (for active antennas) coming from the other card's input. I > suspected a hardware defect, but the two cards were working when I > feeded them separately. I've bought a splitter and connected the two > cards in parallel - everything is working fine now! > > Andreas. > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr ______ BR, Voitto ................................................................... Luukku Plus paketilla p??set eroon tila- ja turvallisuusongelmista. Hanki Luukku Plus ja helpotat el?m??si. http://www.mtv3.fi/luukku
