Andrey Vlassov wrote: > > Thomas, > > I did try channelscan plugin yesteday tonight. I guess that something > was wrong. I position the dish through "rotor" plugin then I run > channelscan and select corresponding .ini file. As only I hit > "Ok" the > dish start to move right (if I look from behind the dish) all > the way to > the west limit. > It looks like the channelscan plugin tuned to a channel of another satellite. So the rotor plugin tries to move the dish to this position. Which ini file did you use (perhaps you can mail it to me)? And which values for site lattitude / longitude have you entered in the setup menu of rotor plugin? Perhaps I can reproduce this error. > I am not sure how "rotor" + "channelscan" work together. I > will try to > figure out it today tonight. rotor and channelscan should work together without problems. The channelscan plugin just switches through channels and the rotor plugin sends the diseqc command according to the desired satellite position. Just the way it does when you manually switch through channels. Thomas
