Hello Dang,
On 03.12.24 11:24, Dang Huynh wrote:
> The Pine64 PineTab 2 tablet is basically the Quartz64 but as
> a finished product.
>
> There are (currently) two revisions, v0.1 and v2.0.
>
> v0.1 was sent to developers and there are a few units around
> (probably less than 10?)
>
> v2.0 is the consumer available version, this version changed the
> display reset pin and hooked WLAN/BT chip to a GPIO.
>
> Signed-off-by: Dang Huynh <danct12@xxxxxxxxxx>
Reviewed-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
> + if (bootsource == BOOTSOURCE_MMC && instance == 0)
> + of_device_enable_path("/chosen/environment-sd");
> + else
> + of_device_enable_path("/chosen/environment-emmc");
> +
> + rockchip_bbu_mmc_register("sd", 0, "/dev/mmc0");
> + rockchip_bbu_mmc_register("emmc", BBU_HANDLER_FLAG_DEFAULT, "/dev/mmc1");
I still think it's useful to set BBU_HANDLER_FLAG_DEFAULT for the SD-card when
SD-booted, i.e.:
int sd_flags = 0, emmc_flags = 0;
if (bootsource == BOOTSOURCE_MMC && instance == 0) {
of_device_enable_path("/chosen/environment-sd");
sd_flags = BBU_HANDLER_FLAG_DEFAULT;
} else {
of_device_enable_path("/chosen/environment-emmc");
emmc_flags = BBU_HANDLER_FLAG_DEFAULT;
}
rockchip_bbu_mmc_register("sd", sd_flags, "/dev/mmc0");
rockchip_bbu_mmc_register("emmc", emmc_flags, "/dev/mmc1");
But I don't have the board, so it's up to you.
Cheers,
Ahmad
--
Pengutronix e.K. | |
Steuerwalder Str. 21 | http://www.pengutronix.de/ |
31137 Hildesheim, Germany | Phone: +49-5121-206917-0 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
