On Tue, 01 Oct 2024 10:52:13 +0200, Sascha Hauer wrote:
> The sabrelite board code uses a GPIO to enable USB VBUS. The same GPIO
> is registered in the device tree as a USB VBUS regulator. This regulator
> currently can't probe because the GPIO is busy due to its usage in board
> code. Free the GPIO after usage in board code to allow probing the VBUS
> regulator.
>
> The board specific code to enable VBUS might not be needed at all
> anymore, but I currently do not have the board handy to try out, so
> for now just avoid the error messages from failed driver probe.
>
> [...]
Applied, thanks!
[1/1] ARM: i.MX6 sabrelite: free USB VBUS GPIO after use
https://git.pengutronix.de/cgit/barebox/commit/?id=3995dd53d2fe (link may not be stable)
Best regards,
--
Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>
