On Wed, May 29, 2024 at 07:03:40AM +0200, Oleksij Rempel wrote: > Add a check in phy_update_status to skip calling adjust_link when the > link status remains down. This prevents unnecessary adjust_link calls > for PHYs that may change speed and duplex status bits before confirming > link establishment. This issue was observed during debugging a switch > driver, where a PHY took about 6 seconds to establish a link, causing > multiple adjust_link calls. > > Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx> > --- > drivers/net/phy/phy.c | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c > index abd78b2c80..39a48e1519 100644 > --- a/drivers/net/phy/phy.c > +++ b/drivers/net/phy/phy.c > @@ -62,6 +62,9 @@ int phy_update_status(struct phy_device *phydev) > phydev->link == oldlink) > return 0; > > + if (!phydev->link && phydev->link == oldlink) > + return 0; I've changed the check to (!phydev->link && !oldlink) which is a bit easier to read. Sascha -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |