The SCI clk driver has an unconditional reference to ti_sci_get_handle(), but no dependency is specific in the Kconfig. Add a dependency and change defaults, so it's enabled by default. Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx> --- drivers/clk/Kconfig | 9 +++++++++ drivers/clk/Makefile | 2 +- drivers/firmware/Kconfig | 1 + 3 files changed, 11 insertions(+), 1 deletion(-) diff --git a/drivers/clk/Kconfig b/drivers/clk/Kconfig index 076e77c8590f..a3772ed56d2a 100644 --- a/drivers/clk/Kconfig +++ b/drivers/clk/Kconfig @@ -38,6 +38,15 @@ config COMMON_CLK_SCMI This driver uses SCMI Message Protocol to interact with the firmware providing all the clock controls. +config TI_SCI_CLK + tristate "TI System Control Interface clock drivers" + depends on TI_SCI_PROTOCOL + default ARCH_K3 + help + This adds the clock driver support over TI System Control Interface. + If you wish to use clock resources from the PMMC firmware, say Y. + Otherwise, say N. + config COMMON_CLK_GPIO bool default y diff --git a/drivers/clk/Makefile b/drivers/clk/Makefile index 3ebafbf7fdad..3a2983c0a030 100644 --- a/drivers/clk/Makefile +++ b/drivers/clk/Makefile @@ -29,4 +29,4 @@ obj-$(CONFIG_MACH_RPI_COMMON) += clk-rpi.o obj-y += bcm/ obj-$(CONFIG_COMMON_CLK_SCMI) += clk-scmi.o obj-$(CONFIG_COMMON_CLK_GPIO) += clk-gpio.o -obj-$(CONFIG_ARCH_K3) += ti-sci-clk.o +obj-$(CONFIG_TI_SCI_CLK) += ti-sci-clk.o diff --git a/drivers/firmware/Kconfig b/drivers/firmware/Kconfig index ee91b2b7fa6d..e37099aa6141 100644 --- a/drivers/firmware/Kconfig +++ b/drivers/firmware/Kconfig @@ -46,6 +46,7 @@ config QEMU_FW_CFG config TI_SCI_PROTOCOL bool "TI System Control Interface (TISCI) Message Protocol" depends on TI_MESSAGE_MANAGER + default ARCH_K3 help TI System Control Interface (TISCI) Message Protocol is used to manage compute systems such as ARM, DSP etc with the system controller in -- 2.39.2
