[PATCH 25/26] Documentation: boards: imx: replace i.MX8MQ with i.MX8M

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Some parts of the documentation refer to the i.MX8MQ which are valid for
all i.MX8M SoCs. Also rename the i.MX8 to i.MX8M to make it clear which
family we meant.

Signed-off-by: Marco Felsch <m.felsch@xxxxxxxxxxxxxx>
---
 Documentation/boards/imx.rst | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/boards/imx.rst b/Documentation/boards/imx.rst
index c64446aff640..a8f014dd1b91 100644
--- a/Documentation/boards/imx.rst
+++ b/Documentation/boards/imx.rst
@@ -21,7 +21,7 @@ The Internal Boot Mode is supported on:
 * i.MX53
 * i.MX6
 * i.MX7
-* i.MX8MQ
+* i.MX8M
 
 With the Internal Boot Mode, the images contain a header which describes
 where the binary shall be loaded and started. These headers also contain
@@ -64,8 +64,8 @@ of the image to the card, use:
 
   dd if=images/barebox-freescale-imx51-babbage.img of=/dev/sdd bs=1024 skip=1 seek=1
 
-Note that MaskROM on i.MX8 expects the image to start at the +33KiB mark, so the
-following command has to be used instead:
+Note that MaskROM on i.MX8M expects the image to start at the +33KiB mark, so
+the following command has to be used instead:
 
 .. code-block:: sh
 
-- 
2.39.2





[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux