Promisc mode is not working if set before starting interface. This seen
more with DSA switch driver when having many interfaces and different
MACs.
Make promisc mode work by saving configs before soft reset, then use
them after reset.
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
drivers/net/designware_eqos.c | 12 +++++++++++-
drivers/net/designware_eqos.h | 3 +++
2 files changed, 14 insertions(+), 1 deletion(-)
diff --git a/drivers/net/designware_eqos.c b/drivers/net/designware_eqos.c
index 845f9f51ef..6caf3a436f 100644
--- a/drivers/net/designware_eqos.c
+++ b/drivers/net/designware_eqos.c
@@ -351,6 +351,9 @@ int eqos_set_ethaddr(struct eth_device *edev, const unsigned char *mac)
memcpy(eqos->macaddr, mac, ETH_ALEN);
+ if (!eqos->is_started)
+ return 0;
+
/* mac_hi is only partially overwritten by the following code. Part of
* this variable is DCS (DMA Channel Select). If this variable is not
* zeroed, we may get some random DMA RX channel.
@@ -371,6 +374,11 @@ static int eqos_set_promisc(struct eth_device *edev, bool enable)
struct eqos *eqos = edev->priv;
u32 mask;
+ eqos->promisc_enabled = enable;
+
+ if (!eqos->is_started)
+ return 0;
+
mask = EQOS_MAC_PACKET_FILTER_PR | EQOS_MAC_PACKET_FILTER_PCF;
if (enable)
@@ -429,8 +437,10 @@ static int eqos_start(struct eth_device *edev)
return ret;
}
- /* Reset above clears MAC address */
+ /* Reset above clears any previously made configuration */
+ eqos->is_started = true;
eqos_set_ethaddr(edev, eqos->macaddr);
+ eqos_set_promisc(edev, eqos->promisc_enabled);
/* Required for accurate time keeping with EEE counters */
rate = eqos->ops->get_csr_clk_rate(eqos);
diff --git a/drivers/net/designware_eqos.h b/drivers/net/designware_eqos.h
index 31d0dc8632..58ba912cd0 100644
--- a/drivers/net/designware_eqos.h
+++ b/drivers/net/designware_eqos.h
@@ -60,6 +60,9 @@ struct eqos {
const struct eqos_ops *ops;
void *priv;
+
+ bool is_started;
+ bool promisc_enabled;
};
struct device;
--
2.39.2
