The required functionality is essential for cable hot plugging or
asynchronous link detection. In its current state, DSA will only operate
if the cable was connected prior to booting.
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
drivers/net/dsa.c | 4 ++--
include/dsa.h | 1 +
2 files changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/net/dsa.c b/drivers/net/dsa.c
index 793bbbb4f1..9c21564876 100644
--- a/drivers/net/dsa.c
+++ b/drivers/net/dsa.c
@@ -104,8 +104,8 @@ static int dsa_port_start(struct eth_device *edev)
return ret;
}
- ret = phy_device_connect(edev, ds->slave_mii_bus, dp->index, NULL, 0,
- interface);
+ ret = phy_device_connect(edev, ds->slave_mii_bus, dp->index,
+ ops->adjust_link, 0, interface);
if (ret)
return ret;
diff --git a/include/dsa.h b/include/dsa.h
index e823bac0a7..527941c269 100644
--- a/include/dsa.h
+++ b/include/dsa.h
@@ -55,6 +55,7 @@ struct dsa_switch_ops {
int (*phy_read)(struct dsa_switch *ds, int port, int regnum);
int (*phy_write)(struct dsa_switch *ds, int port, int regnum, u16 val);
+ void (*adjust_link)(struct eth_device *dev);
};
struct dsa_port {
--
2.30.2
