The barebox CAAM driver only ever ran on i.MX6 (32-bit little-endian
i.MX). There are also CAAM units on Layerscape and i.MX8. Prepare for
their support by syncing the current 64-bit accessors from Linux.
In addition to the existing caam_little_end, these can also consult
the caam_imx and caam_ptr_sz globals. They are for now initialized
to maintain i.MX6 compatibility, but may be initialized dynamically
in future.
Signed-off-by: Ahmad Fatoum <a.fatoum@xxxxxxxxxxxxxx>
---
drivers/crypto/caam/ctrl.c | 6 ++
drivers/crypto/caam/regs.h | 192 +++++++++++++++++++++++++++----------
2 files changed, 146 insertions(+), 52 deletions(-)
diff --git a/drivers/crypto/caam/ctrl.c b/drivers/crypto/caam/ctrl.c
index f78940e1ac91..2e44f60c7f86 100644
--- a/drivers/crypto/caam/ctrl.c
+++ b/drivers/crypto/caam/ctrl.c
@@ -26,6 +26,12 @@
bool caam_little_end;
EXPORT_SYMBOL(caam_little_end);
+bool caam_imx = true;
+EXPORT_SYMBOL(caam_imx);
+
+size_t caam_ptr_sz = 4;
+EXPORT_SYMBOL(caam_ptr_sz);
+
/*
* Descriptor to instantiate RNG State Handle 0 in normal mode and
* load the JDKEK, TDKEK and TDSK registers
diff --git a/drivers/crypto/caam/regs.h b/drivers/crypto/caam/regs.h
index f80ece94fde9..5c4b783e80fe 100644
--- a/drivers/crypto/caam/regs.h
+++ b/drivers/crypto/caam/regs.h
@@ -2,33 +2,93 @@
/*
* CAAM hardware register-level view
*
- * Copyright 2008-2015 Freescale Semiconductor, Inc.
+ * Copyright 2008-2011 Freescale Semiconductor, Inc.
+ * Copyright 2018 NXP
*/
#ifndef REGS_H
#define REGS_H
#include <linux/types.h>
+#include <linux/bitops.h>
#include <io.h>
+#include <io-64-nonatomic-hi-lo.h>
-extern bool caam_little_end;
+/*
+ * Architecture-specific register access methods
+ *
+ * CAAM's bus-addressable registers are 64 bits internally.
+ * They have been wired to be safely accessible on 32-bit
+ * architectures, however. Registers were organized such
+ * that (a) they can be contained in 32 bits, (b) if not, then they
+ * can be treated as two 32-bit entities, or finally (c) if they
+ * must be treated as a single 64-bit value, then this can safely
+ * be done with two 32-bit cycles.
+ *
+ * For 32-bit operations on 64-bit values, CAAM follows the same
+ * 64-bit register access conventions as it's predecessors, in that
+ * writes are "triggered" by a write to the register at the numerically
+ * higher address, thus, a full 64-bit write cycle requires a write
+ * to the lower address, followed by a write to the higher address,
+ * which will latch/execute the write cycle.
+ *
+ * For example, let's assume a SW reset of CAAM through the master
+ * configuration register.
+ * - SWRST is in bit 31 of MCFG.
+ * - MCFG begins at base+0x0000.
+ * - Bits 63-32 are a 32-bit word at base+0x0000 (numerically-lower)
+ * - Bits 31-0 are a 32-bit word at base+0x0004 (numerically-higher)
+ *
+ * (and on Power, the convention is 0-31, 32-63, I know...)
+ *
+ * Assuming a 64-bit write to this MCFG to perform a software reset
+ * would then require a write of 0 to base+0x0000, followed by a
+ * write of 0x80000000 to base+0x0004, which would "execute" the
+ * reset.
+ *
+ * Of course, since MCFG 63-32 is all zero, we could cheat and simply
+ * write 0x8000000 to base+0x0004, and the reset would work fine.
+ * However, since CAAM does contain some write-and-read-intended
+ * 64-bit registers, this code defines 64-bit access methods for
+ * the sake of internal consistency and simplicity, and so that a
+ * clean transition to 64-bit is possible when it becomes necessary.
+ *
+ * There are limitations to this that the developer must recognize.
+ * 32-bit architectures cannot enforce an atomic-64 operation,
+ * Therefore:
+ *
+ * - On writes, since the HW is assumed to latch the cycle on the
+ * write of the higher-numeric-address word, then ordered
+ * writes work OK.
+ *
+ * - For reads, where a register contains a relevant value of more
+ * that 32 bits, the hardware employs logic to latch the other
+ * "half" of the data until read, ensuring an accurate value.
+ * This is of particular relevance when dealing with CAAM's
+ * performance counters.
+ *
+ */
-#define caam_to_cpu(len) \
-static inline u##len caam##len ## _to_cpu(u##len val) \
-{ \
- if (caam_little_end) \
- return le##len ## _to_cpu(val); \
- else \
- return be##len ## _to_cpu(val); \
+extern bool caam_little_end;
+extern bool caam_imx;
+extern size_t caam_ptr_sz;
+
+#define caam_to_cpu(len) \
+static inline u##len caam##len ## _to_cpu(u##len val) \
+{ \
+ if (caam_little_end) \
+ return le##len ## _to_cpu((__force __le##len)val); \
+ else \
+ return be##len ## _to_cpu((__force __be##len)val); \
}
-#define cpu_to_caam(len) \
-static inline u##len cpu_to_caam##len(u##len val) \
-{ \
- if (caam_little_end) \
- return cpu_to_le##len(val); \
- else \
- return cpu_to_be##len(val); \
+#define cpu_to_caam(len) \
+static inline u##len cpu_to_caam##len(u##len val) \
+{ \
+ if (caam_little_end) \
+ return (__force u##len)cpu_to_le##len(val); \
+ else \
+ return (__force u##len)cpu_to_be##len(val); \
}
caam_to_cpu(16)
@@ -63,67 +123,95 @@ static inline void clrsetbits_32(void __iomem *reg, u32 clear, u32 set)
}
/*
- * The DMA address registers in the JR are a pair of 32-bit registers.
- * The layout is:
+ * The only users of these wr/rd_reg64 functions is the Job Ring (JR).
+ * The DMA address registers in the JR are handled differently depending on
+ * platform:
+ *
+ * 1. All BE CAAM platforms and i.MX platforms (LE CAAM):
*
* base + 0x0000 : most-significant 32 bits
* base + 0x0004 : least-significant 32 bits
*
* The 32-bit version of this core therefore has to write to base + 0x0004
- * to set the 32-bit wide DMA address. This seems to be independent of the
- * endianness of the written/read data.
+ * to set the 32-bit wide DMA address.
+ *
+ * 2. All other LE CAAM platforms (LS1021A etc.)
+ * base + 0x0000 : least-significant 32 bits
+ * base + 0x0004 : most-significant 32 bits
*/
-
-#ifdef CONFIG_64BIT
static inline void wr_reg64(void __iomem *reg, u64 data)
{
- if (caam_little_end)
- iowrite64(data, reg);
- else
+ if (caam_little_end) {
+ if (caam_imx) {
+ iowrite32(data >> 32, (u32 __iomem *)(reg));
+ iowrite32(data, (u32 __iomem *)(reg) + 1);
+ } else {
+ iowrite64(data, reg);
+ }
+ } else {
iowrite64be(data, reg);
+ }
}
-static inline void rd_reg64(void __iomem *reg)
+static inline u64 rd_reg64(void __iomem *reg)
{
- if (caam_little_end)
- ioread64(reg);
- else
- ioread64be(reg);
+ if (caam_little_end) {
+ if (caam_imx) {
+ u32 low, high;
+
+ high = ioread32(reg);
+ low = ioread32(reg + sizeof(u32));
+
+ return low + ((u64)high << 32);
+ } else {
+ return ioread64(reg);
+ }
+ } else {
+ return ioread64be(reg);
+ }
}
-#else /* CONFIG_64BIT */
-static inline void wr_reg64(void __iomem *reg, u64 data)
+
+static inline u64 cpu_to_caam_dma64(dma_addr_t value)
{
- wr_reg32((u32 __iomem *)(reg), data >> 32);
- wr_reg32((u32 __iomem *)(reg) + 1, data);
+ if (caam_imx) {
+ u64 ret_val = (u64)cpu_to_caam32(lower_32_bits(value)) << 32;
+
+ if (IS_ENABLED(CONFIG_ARCH_DMA_ADDR_T_64BIT))
+ ret_val |= (u64)cpu_to_caam32(upper_32_bits(value));
+
+ return ret_val;
+ }
+
+ return cpu_to_caam64(value);
}
-static inline u64 rd_reg64(void __iomem *reg)
+static inline u64 caam_dma64_to_cpu(u64 value)
{
- return ((u64)rd_reg32((u32 __iomem *)(reg)) << 32 |
- (u64)rd_reg32((u32 __iomem *)(reg) + 1));
+ if (caam_imx)
+ return (((u64)caam32_to_cpu(lower_32_bits(value)) << 32) |
+ (u64)caam32_to_cpu(upper_32_bits(value)));
+
+ return caam64_to_cpu(value);
}
-#endif /* CONFIG_64BIT */
-static inline u64 cpu_to_caam_dma64(dma_addr_t value)
+static inline u64 cpu_to_caam_dma(u64 value)
{
- return (((u64)cpu_to_caam32(lower_32_bits(value)) << 32) |
- (u64)cpu_to_caam32(upper_32_bits(value)));
+ if (IS_ENABLED(CONFIG_ARCH_DMA_ADDR_T_64BIT) &&
+ caam_ptr_sz == sizeof(u64))
+ return cpu_to_caam_dma64(value);
+ else
+ return cpu_to_caam32(value);
}
-static inline u64 caam_dma64_to_cpu(u64 value)
+static inline u64 caam_dma_to_cpu(u64 value)
{
- return (((u64)caam32_to_cpu(lower_32_bits(value)) << 32) |
- (u64)caam32_to_cpu(upper_32_bits(value)));
+ if (IS_ENABLED(CONFIG_ARCH_DMA_ADDR_T_64BIT) &&
+ caam_ptr_sz == sizeof(u64))
+ return caam_dma64_to_cpu(value);
+ else
+ return caam32_to_cpu(value);
}
-#ifdef CONFIG_ARCH_DMA_ADDR_T_64BIT
-#define cpu_to_caam_dma(value) cpu_to_caam_dma64(value)
-#define caam_dma_to_cpu(value) caam_dma64_to_cpu(value)
-#else
-#define cpu_to_caam_dma(value) cpu_to_caam32(value)
-#define caam_dma_to_cpu(value) caam32_to_cpu(value)
-#endif /* CONFIG_ARCH_DMA_ADDR_T_64BIT */
-
/*
* jr_outentry
* Represents each entry in a JobR output ring
--
2.30.2
