This configuration is mostly needed for controllers attached to switches
with different MAC address configurations or for debugging networking
issues.
Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
---
include/net.h | 3 +++
net/eth.c | 8 ++++++++
2 files changed, 11 insertions(+)
diff --git a/include/net.h b/include/net.h
index 338033d698..f9d1fbfc18 100644
--- a/include/net.h
+++ b/include/net.h
@@ -49,6 +49,8 @@ struct eth_device {
int *length);
void (*rx_monitor) (struct eth_device*, void *packet, int length);
void (*tx_monitor) (struct eth_device*, void *packet, int length);
+ /* Set promiscuous mode */
+ int (*set_promisc) (struct eth_device*, bool enable);
struct eth_device *next;
void *priv;
@@ -113,6 +115,7 @@ int eth_send(struct eth_device *edev, void *packet, int length); /* Send a pa
int eth_rx(void); /* Check for received packets */
void eth_open_all(void);
struct eth_device *of_find_eth_device_by_node(struct device_node *np);
+int eth_set_promisc(struct eth_device *edev, bool enable);
/* associate a MAC address to a ethernet device. Should be called by
* board code for boards which store their MAC address at some unusual
diff --git a/net/eth.c b/net/eth.c
index 8f6ff7db3a..19654cdd51 100644
--- a/net/eth.c
+++ b/net/eth.c
@@ -31,6 +31,14 @@ struct eth_ethaddr {
static LIST_HEAD(ethaddr_list);
+int eth_set_promisc(struct eth_device *edev, bool enable)
+{
+ if (!edev->set_promisc)
+ return -EOPNOTSUPP;
+
+ return edev->set_promisc(edev, enable);
+}
+
int eth_set_ethaddr(struct eth_device *edev, const char *ethaddr)
{
int ret;
--
2.30.2
